creativecommons.org
The popularity of leggings is growing every year. This accessory has been appearing in the wardrobes of fashionistas for more than ten years, and is still considered stylish. The advantage of the thing is that it visually increases the length of the legs, warms you up in cold weather and makes the simplest look original. Previously, only athletes wore leg warmers. It was an indispensable attribute of a football uniform, gymnastics suit, and aerobic outfit. Over time, they went beyond the sports theme and replaced knee socks, which at that time were a popular addition to the female image. Unlike knee socks, leg warmers can be made from any material. Fashion designers use yarn, fur, leather, fabric to create an accessory. If it is quite difficult to sew knee socks with your own hands, then with leggings the issue is simpler.
How to sew fur leg warmers on boots with your own hands - a short guide
creativecommons.org
The prestigious accessory is usually worn with low shoes or boots.It is advisable that the shoes be classic. However, modern eclecticism in fashion allows you to experiment. For example, knee-length fur leg warmers with high-heeled boots will look good. It’s not a problem if the desired model cannot be found in stores and shopping centers. Fur insulation is easy to make yourself. To do this you need to prepare:
- Fur pieces – 2 pieces. Standard length is 40 centimeters wide, 80 centimeters long. The parameters are adjusted in accordance with the leg circumference and the desired height of the product.
- Pins, thread, needle, scissors.
- Knitted material. An alternative solution could be cuffs from an old sweater.
A cuff is an element that must match the circumference of the model’s leg in the ankle area. You need to check the volume, if the part is large, cut it, remove the excess and sew it again. The calf circumference is measured and a corresponding rectangle is cut out on the fur fabric. The cuff is connected to the fur and sewn along the side seams. Then the product is turned outward.
How to sew fur leg warmers - detailed diagram
Let's take a closer look at the process of sewing fur leggings. A pattern is not required for this accessory. The process is quite simple. It consists of several stages:
- We take measurements. Using a measuring tape, measure your leg below the knee. Add 2.5 centimeters to the parameter. Otherwise, the leg will be uncomfortable due to the tight elastic band.
- We measure the calves in the widest possible areas.
- We measure the lower area of the shin. We calculate the length of the product. We start measuring from the ankle and bring the tape almost to the knees. We transfer all measurements to the material.
- We cut the fur into two fragments.The width of one piece is the length, the length of the patch is equal to the volume of the calves on the widest part of the leg. Add two centimeters to the allowance.
- Align the pieces on a flat surface with the lining facing up. We put aside all the measurements.
- We get three horizontal lines. The first is in the ankle area. This is the bottom of the product. The second is in the center, the third is the upper part of the leggings. We put rubber bands under all parts. It is recommended to sew them in the following order: top, bottom and center.
- We attach the elastic bands, they should be slightly stretched.
- Fold the material in half. We sew the product with a hidden edge seam. It will not be visible under the fluffy fur. It is better to make the seam by hand, but for the edge stitches you can use a machine.
- If the fabric is synthetic, the obligatory hem at the bottom can be omitted.
- We process the second part in the same way as the first part.
While working, it is advisable to try the product on your foot. This will avoid inaccuracies.
0
