Pulling technique in embroidery: what is it, what is it for, how to do it

creativecommons.org

The tugging technique is a special knitting technique. You don't need knitting needles to work, just a special needle or hooks. Depends on the selected product creation option. The work can use thread of any color. The yarn is selected to match the pattern. You will also need a canvas with a pre-made image diagram. It is easier for beginning needlewomen to purchase a ready-made kit for embroidery using the pull-through technique. It has everything you need to create a basic decorative piece. Sets vary depending on difficulty level.

Carpet weaving - embroidery, advice from an expert

Before you start working in a new style, it is advisable to study the basic nuances of the technique in advance:

1. To change the direction of embroidery, the needle is set to the lower position when the fabric is pierced. It does not rotate, only the position of the hoop changes.
2. Loops that pop out during knitting may indicate the presence of knots on the thread.
3. During work, you should regularly check the face covering. The loops must lie with maximum precision, be even and identical. The first stitches are characterized by slight deformations. They will straighten out gradually as the pattern is embroidered. To do this, the elements must be dense.
4. To maintain clear boundaries between different shades, pulling is done along the contours, along the inside of the line on the material.
5. You should not make stitches as close to each other as possible. If necessary, the master goes back and fills in areas that are not embroidered tightly enough.
6. Almost any material is suitable for embroidery. The density of the fabric depends on the thickness of the needle. After the work is completed, the material is not visible behind the threads. Good products are made on calico.
7. In some cases, it is necessary to remove the last loops and redo certain areas. To do this, just pull the thread on the other side. The loops will begin to come out one by one. If the thread that was pulled out is too broken, it is better to replace it with a new thread.

Pulling the thread - the first stage

creativecommons.org

After preparing all the necessary materials, you can begin to work. At the initial stage it is necessary:

• Place the needle in a perpendicular position relative to the material that is stretched on the hoop.
• Remove the thread that comes out of the eye of the needle by your hand. This way it won't interfere with work. It is important that no knots are formed on the working thread.
• Thread the needle through the material, lifting it above the canvas until the tip is visible.
• Step back 1-2 mm from the finished stitch. Thread the needle again.It should always be perpendicular to the fabric.
• During operation, the front part of the canvas will be filled with loops. They form the future image.
• When four stitches have been made, cut the remaining thread at the start to five millimeters. If the end is pulled out, the entire embroidery will unravel.

Pulling technique - work process

Next you need to act gradually:

• The long end of the thread gradually disappears at the top of the needle. We make a few stitches. Press the outer stitch with your hands and pull the thread out of the needle.
• Cut the thread next to the fabric. To secure the end, you need to use textile glue.
• The needle does not move a long distance from the last stitch if the master begins to work on another section. It is advisable to cut the thread, then start processing the new area first.
• You should start by processing large elements, then move on to straight and small areas.
• Embroidery begins with working on the contours, then filling in the inside using lines or circular movements. You can use both methods, alternating them.
• Double pulling is used to create a straight line. This way it turns out as clear as possible.